5. Apply power (AC or PoE) to Bell Controller.
Surface mount bell controller
A Bell Controller can be mounted to the outside surface of a fixture, wall, or another type of unit using the supplied
3M™ Dual Lock™ Tape strips.
1. Remove the device cover; simultaneously press the two tabs located on the top side of the device.
2. Insert the 3.0v Primex Lithium/Iron Disulfide Battery Pack or two 1.5v Lithium AA batteries. Follow the symbols
showing the correct way to position the positive (+) and negative (-) ends of the battery pack.
3. Located to the lower-right of the battery compartment, set the battery on/off switch to the Up (On) position.
4. Replace the device cover.
5. Prepare the mounting area to ensure maximum adhesion. If there is moisture, dry the area first.
6. Apply two pieces of the supplied 3M™ Dual Lock™ Tape to the back of the device; top and bottom, horizontally
centered.
7. Apply two pieces of the supplied 3M™ Dual Lock™ Tape to the mounting surface; align with the device tape
position.
8. Affix the device to the mounting surface.
It's recommended to dress the cables with self-adhesive hook-and-loop mounting tape.
9. Apply power to the bell controller; AC or PoE.
10. When power was applied, the device automatically initiated a check-in to OneVue. Verify its LCD displays Signal
OK, which indicates it successfully checked-in to OneVue.
If the LCD screen does not display Signal OK, it's recommended to initiate a manual check-in to validate the
device can connect to the facility network and OneVue at its install location. Press and release its check-in button
. The device emits a series of audio beeps indicating its connection sequence.
During an active check-in connection, additional pressing of the check-in button is ignored.
1 beep: device booted
2 beeps: device connected to network
3 beeps: device connected to OneVue
Wall mount bell controller
A Bell Controller can be mounted directly to a wall surface by way of a key-hole mount or screw mount that n be
applied with the use of two #6" drywall screws and anchors.
1. Remove the device cover; simultaneously press the two tabs located on the top side of the device.
2. Insert the 3.0v Primex Lithium/Iron Disulfide Battery Pack or two 1.5v Lithium AA batteries. Follow the symbols
showing the correct way to position the positive (+) and negative (-) ends of the battery pack.
3. Located to the lower-right of the battery compartment, set the battery on/off switch to the Up (On) position.
4. Replace the device cover.
Page 12
