Primes MicroSpotMonitor Plus HighBrilliance, Оригинальное руководство пользователя

Страница: 38 / 116

38
Revision 00 EN - 02/2022
MSM+ HB
35,0(6
8.5 Safety Circuit PLM In (option)
This connection is only used if you are using a PowerLossMonitor PLM for power measurement.
NOTICE
Danger of damage due to overheating
If the safety circuit is not connected, the device can be damaged due to overheating.
X
Connect the Safety Interlock of the PowerLossMonitor PLM to the MSM+ HB.
X
Check that the laser is switched off properly by the external safety circuit in the event of a
fault.
The Safety Interlock protects from damage by switching off the laser in the following cases:
• The water flow is too low.
Make sure that the Safety Interlock MSM connector on the PowerLossMonitor PLM is connected to the
Safety Circuit PLM-In connector on the MSM+ HB. Use the enclosed 8-pin cable, which is pre-assembled
on both sides.
The interlock connection provides two redundant safety circuits.
8.6 Safety Circuit Fiber Out (option)
This connection is only used if you are using a fiber bridge to connect a laser.
The Safety Interlock protects against damage by switching off the laser in the following cases:
• The fiber is not mounted correctly.
Make sure that the safety interlock connection on the fiber holder is connected to the Safety Circuit Fiber Out
connector at the MSM+ HB. Use the enclosed 3-pin cable.
8.7 Inlet external trigger (In)
BNC connector (view: connector side)
1
2
Pin Function
1 +5 V (Trigger signal)
2 GND
Tab. 8.3: Connection socket inlet for an external trigger in the connection panel
8.8 Outlet internal trigger (Out)
BNC connector (view: connector side)
1
2
Pin Function
1 +5 V (Trigger signal)
2 GND
Tab. 8.4: Connection socket outlet for the internal trigger in the connection panel