Primera Cyclone C-1000, Руководство пользователя

Страница: 29 / 66

Command Language Quick Reference 25
Appendix A: Command Language
Quick Reference
This section lists all internal software commands for the printer
if you are installing it in a “legacy” application in which a
specific printer programming language is being used. For
more information please refer to the Programmer’s Manual,
available separately from the factory or your Authorized
Reseller. This section does not apply if you are using the
printer with the included Windows-compatible driver and
Windows application software.
A. COMMAND SET FOR PPLA
The following commands are for Printer Programming
Language A.
System Setting Commands
These commands will cause related parameters to be saved in
the permanent storage, E2PROM. The parameters will be
stored unless they are changed by commands or a reset from
the front panel.
Command Description Parameter Factory default
<STX>KI4 n Media empty n: ‘0’ - disable enabled
check ‘1’ - enable.
<STX>KI7 n Set ribbon n: ‘0’ – DT, TT with ribbon
mode ‘1’ – TT.
<STX>KI8 n Set baud rate m: ‘0’ – 9600, 9600 baud.
‘1’ – 600,
‘2’ – 2400,
‘3’ – 19200,
‘4’ – 4800,
‘5’ – 38400,
‘6’ – 1200,
‘7’ – 9600.
<STX>KI;1 Select alternate !KI;0 - selects
Control codes standard
control
codes.
<STX>KX nnnn Set continuous nnnn: a 4-digit Valid under
label length number, Windows driver
in mm Label Dr.
510172_r1.qxd 3/21/2001 6:25 PM Page 25
All manuals and user guides at all-guides.com