Primera AP550e, Руководство оператора

Страница: 6 / 32

6 AP550e Label Applicator
AP550
LABEL AP
PLICATOR
Mode Recall
Reset +
-
4. Place the Roll Drag Arm under the Roll Bar. The Roll Drag Arm may be placed on either
side of the Roll Bar but the rounded tip of the Roll Drag Arm should be located inside the
core near the center. The arm is spring loaded so that there is downward pressure on the
inside of the roll. This helps prevent problems toward the end of a roll.
5. Place the removed Roll Guide back on the Roll Bar and slide it close to, but not pinching the
label stock roll.
6. Pull approximately 12" [30 cm] of label stock out beyond the front of the unit.
7. Remove approximately the first 15" [38 cm] of labels from the liner. This will be important
later when you calibrate the label sensor to the label stock.
Roll Drag Arm
Tip! Roll Guide Uprights
must not pinch the label
stock roll. (The label stock
roll must have free-play
between the guides.)
15"
[38 cm]