Victory 9/10 Technical Troubleshooting Guide www.pridemobility.com 15
From step 19
22. Unplug connector 16b from connector 17a.
See diagram 2
.
23. Turn the speed pot (17) to the full rabbit position.
24. Measure resistance across pin 1 and pin 2 on connector 17a.
See figure 36
.
— If your multimeter indicates about 100k ohms,
then go to the
next step.
—
If your multimeter does not indicate about 100k ohms,
then
replace the speed pot (17) and retest the system.
25. Turn the speed pot (17) to the full turtle position.
26. Measure resistance across pin 2 and pin 3 on connector 17a.
See figure 37
.
— If your multimeter indicates about 100k ohms,
then replace the
console (16) and retest the system.
—
If your multimeter does not indicate about 100k ohms,
then
replace the speed pot (17) and retest the system.
Beep Code #8 - Motor Disconnected
Symptoms:
The controller (8) beeps eight times.
Diagnosis:
The motor (19) is not functioning properly or is disconnected.
The controller (8) is not functioning properly.
Solution:
Use the following procedure to clear the beep code:
1. Seperate the front and rear halves of the scooter. Refer to the
scooter owner’s manual.
2. Measure resistance across pin 1 and pin 2 on connector 19a.
See figure 38
.
— If your multimeter indicates about 0.5-1.5 ohms,
then go to
step 4
.
—
If your multimeter does not indicate about 0.5-1.5 ohms,
then
go to the next step.
Figure 37. Connector 17a
Figure 38. Connector 19a
Figure 36. Connector 17a
