Pride Victory 10, Руководство по техническому устранению неисправностей

Страница: 14 / 21

14 www.pridemobility.com Victory 9/10 Technical Troubleshooting Guide
Figure 30. Connector 10a
Figure 31. Connector 10a
From step 5 or 6
9. Unplug connector 7d from connector 10a. See diagram 2 .
10. Measure resistance across pin 3 and pin 5 on connector
10a. See figure 30 .
—— If your multimeter indicates about 4.7k ohms, then go to
the next step.
—— If your multimeter does not indicate about 4.7k ohms, then
go to step 14 .
11. Measure resistance across pin 3 and pin 4 on connector
10a. See figure 31 .
—— If your multimeter indicates about 2.5k ohms, then go to
the next step.
—— If your multimeter does not indicate about 2.5k ohms, then
go to step 14 .
12. Turn the speed pot (17) to the full rabbit position.
13. Measure resistance across pin 3 and pin 6 on connector
10a. See figure 32 .
—— If your multimeter does not indicate about 4.7k ohms, then
go to the next step.
—— If your multimeter indicates about 4.7k ohms, then replace
the controller interface harness (7) and retest the system.
From step 10 or 11
14. Remove the front and rear tiller shrouds and the console
assembly. See figure 16 .
15. Unplug connector 10h from connector 15a. See diagram 2 .
16. Measure resistance across pin 1 and pin 2, then across pin
2 and pin 3 on connector 15a. See figure 33 .
—— If your multimeter indicates about 2.5k ohms for both
measurements, then go the next step.
—— If your multimeter does not indicate about 2.5k ohms for
either measurement, then replace the throttle pot (15) and
retest the system.
17. Unplug connector 10g from connector 16a. See diagram 2 .
18. Turn the speed pot (17) to the full rabbit position.
19. Measure resistance across pin 6 and pin 8 on connector 16a.
See figure 34 .
—— If your multimeter indicates about 100k ohms, then go to
the next step.
—— If your multimeter does not indicate about 100k ohms,
then go to step 22 .
20. Turn the speed pot (17) to the full turtle position.
21. Measure resistance across pin 6 and pin 7 on connector
16a. See figure 35 .
—— If your multimeter indicates about 100k ohms, then
replace the tiller harness (10) and retest the system.
—— If your multimeter does not indicate about 100k ohms,
then go to the next step.
Figure 33. Connector 15a
Figure 32. Connector 10a
Figure 34. Connector 16a
Figure 35. Connector 16a