Pride Victory 10, Руководство по техническому устранению неисправностей

Страница: 10 / 21

10 www.pridemobility.com Victory 9/10 Technical Troubleshooting Guide
Figure 20. Connector 16a
Figure 21. Connector 10a
8. Reconnect the batteries and retest the system.
—— If the scooter drives, then replace the controller programming
harness and run plug (6) and retest the system.
—— If the scooter powers up but does not drive, then go to the next step.
9. Unplug connector 7a from connector 8a. See diagram 3 .
10. Measure resistance across pin 2 and pin 3 on connector 12a.
See figure 19 .
—— If your multimeter indicates an open, then replace the
controller (8) and retest the system.
—— If your multimeter indicates less than 1 ohm, then go to the
next step.
11. Unplug connector 10a from connector 7d. (Connector 7d is
located under the front shroud, near the front wheel.) See
diagram 2 .
12. Measure resistance across pin 2 and pin 3 of connector 12a.
See figure 19 .
—— If your multimeter indicates an open, then replace the
controller interface harness (7) and retest the system.
—— If your multimeter indicates less than 1 ohm, then go to the
next step.
13. Unplug connector 12b from connector 10c. See diagram 2 .
14. Measure resistance across pin 2 and pin 3 of connector 12a.
See figure 19 .
—— If your multimeter indicates an open, then replace the tiller
harness (10) and retest the system.
—— If your multimeter indicates less than 1 ohm, then replace the
off-board charger harness (12) and retest the system.
From step 4
15. Remove the front and rear tiller shrouds and the console
assembly. See figure 16 .
16. Unplug connector 16a from connector 10g. See diagram 2 .
17. Insert the key all the way into the key switch and turn the key
switch completely clockwise.
18. Measure resistance from pin 1 to pin 2 on connector 16a. See
figure 20 .
—— If your multimeter indicates an open, then replace the console
(16) and retest the system.
—— If your multimeter indicates less than 1 ohm, then plug
connector 16a back into connector 10g and go to the next step.
19. With the key still inserted and turned to the ON position,
unplug connector 10a from connector 7d. (Connector 7d is
located under the front shroud, near the front wheel).
See
diagram 2 .
20. Measure resistance from pin 1 to pin 2 on connector 10a. See
figure 21 .
—— If your multimeter indicates an open, then replace the tiller
harness (10) and retest the system.
—— If your multimeter indicates less than 1 ohm, then plug
connector 10a back into connector 7d and go to the next step.