Pride Mobility Go-Go Travel Lift, Руководство пользователя

Страница: 10 / 19

10
Go-Go Travel Lift www.pridemobility.com
ADJUSTMENT PIN
TOP TUBE
LIFTING
HOOK
ADJUSTMENT HOLES
BOTTOM TUBE
!
!
Figure 7. Split Ring Collar
Figure 8. Boom Arm Adjustment
SCREWS
BOW TIE COTTER PIN
SECURE NO CLOSER THAN 5”
(12.5 CM) FROM THE TOP OF
THE POST.
I I I . I N S T A L L A T I O N
SPLIT RING COLLAR ADJUSTMENT
The split ring collar is the height adjustment for the motor
housing. See figure 7. The placement of the split ring
collar determines the height of the motor housing.
"
Lower the collar when more room is needed over-
head to swing the boom arm inside a vehicle.
"
Raise the collar when more height is needed to en-
able a scooter to be lifted into a trunk.
To adjust the split ring collar:
1. Loosen the two screws on the collar. See figure 7.
2. Raise or lower the collar to the height you may need.
3. Tighten the screws
BOOM ARM ADJUSTMENT
Before adjusting the boom arm, lower the lifting hook
about 12 in. (30 cm). This will provide enough slack in
the strap to enable the adjustable portion of the boom
arm (top tube) to be pulled out of the bottom tube to its
farthest adjustment hole. See figure 8.
To adjust the boom arm:
1. Remove the bow tie cotter pin from the adjustment
pin and remove the adjustment pin.
2. Slide the top tube in or out to the desired adjustment
hole.
3. Align the adjustment holes of the top and bottom tube
and reinsert the adjustment pin.
NOTE: Do not force the pin into the adjustment
hole. Be sure that the strap is not pinched when
inserting the pin.
4. Reinstall the bow tie cotter pin.
L-BASE INSTALLATION
After determining the ideal spot for your lift to be permanently mounted, remove the entire lift from the vehicle
except for the L-base.
1. Inspect the undercarriage of the vehicle where the lift L-base is located for obstructions that may hinder the
installation of the five (5) mounting bolts that will secure the L-base to the vehicle. Obstructions may consist of
electrical wiring, gas tank, bumper mounts, or exhaust pipes. You may need to adjust the base extensions to
clear obstructions. If possible, install the L-base with the base extensions fully extended. See figure 9.
WARNING! The bumper mounts on some vehicles are gas pressured. DO NOT drill into
them. They may explode casing severe injury.