Pride Mobility Go-Go Travel Lift, Руководство пользователя

Страница: 16 / 19

16
Go-Go Travel Lift www.pridemobility.com
V . T R O U B L E S H O O T I N G
LIFT WILL NOT OPERATE
"
Check the circuit breaker reset button. Reset if
necessary. See figure 18.
"
Ensure all harness connections are secure.
"
Ensure the power wire leading to the positive
battery terminal is tight and not corroded.
"
Check the fuse located on the red power wire
near the battery. If blown, replace with a new
25-amp fuse. See figure 19.
WARNING! Do not use a higher
rated fuse than 25-amp. Doing so
may damage the lift’s electrical
system.
LIFT STOPS OPERATING
If your Go-Go Travel Lift is heavily strained because
of excessive loads, the main circuit breaker (see fig-
ure 18) may trip to protect the motor and electronics
from damage. When the breaker trips, the entire elec-
trical system shuts down.
WARNING! Never attempt to lift
more than 130 lbs. (60 kg) with the
Go-Go Travel Lift.
CIRCUIT BREAKER RESET
BUTTON
Figure 18. Circuit Breaker Reset Button
Figure 19. Fuse Replacement
WORKING FUSE BLOWN FUSE
To reset the main circuit breaker:
1. Allow a minute or so for the electronics to “cool.”
2. Push in the reset button to reset the breaker.
If the breaker trips frequently, contact your authorized Pride Provider.
LIFTING STRAP TRAVELS IN OPPOSITE DIRECTION OF BUTTON BEING PUSHED
ON HAND CONTROL
Before each use, check that the lifting strap is traveling in the proper direction. If the belt travels in the wrong
direction when you press either the up or down button, you must restore proper lifting strap travel.
To restore proper lifting strap travel:
1. Pull slightly on the strap and operate the lift until the strap is extended completely past the “stop” warning label.
2. Allow the strap to rewind itself. Do not allow any twists in the belt.
Observe the travel of the belt: it should correspond with the button being pushed on the hand control. If you are still
experiencing problems, contact your authorized Pride Provider.