PRG BEST BOY HP SPOT LUMINAIRE, Руководство по обслуживанию

Страница: 27 / 241

BEST BOY
®
HP SPOT LUMINAIRE
|
SERVICE MANUAL
|
TROUBLESHOOTING
PAGE
17
Mechanism Errors
Errors will be shown after the mechanism code, for example: PAN:Comm Error.
Error Code Explanation Solution
Cal Error
Error resetting position values in motion
processor at beginning of calibration
Check CAN cables/connections,
motor control board
Cal Timeout
An action during calibration
took longer than expected
Check CAN cables/connections,
motor control board
Comm Error
Error communicating
with motion processor
Check CAN cables/connections,
motor control board
Get Position Error
Error when retrieving current position
from motion processor
Check CAN cables/connections,
motor control board
Init Error
Error during initialization
of motion processor
Check CAN cables/connections,
motor control board
Motion Error
Mechanism's actual position
is too far from its commanded position
Check mechanism motion
No Sensor
During calibration, no sensor was found
in the range of travel
Check for mechanism motion,
sensor operation
No Stop
Mechanism which calibrates
to a physical stop did not find that stop
Check mechanism
Sensor Stuck
During calibration, could not find either
the edge of the sensor, or the sensor
did not turn off as expected
Check for mechanism motion,
sensor operation
Spin Error
Error while sending spin command
to motion processor
Check CAN cables/connections,
motor control board
Stop Spin Error
Error while sending stop spin command
to motion processor
Check CAN cables/connections,
motor control board