PREVOST Le Mirage XL II Ultimate, Руководство по обслуживанию

Страница: 9 / 53

XL2 SLIDE-OUT SERVICE MANUAL
Caution: Be careful when moving the slide-out
to prevent any damage to the slide-out itself
and/or its seal. When moving the slide-out,
check constantly its four corners from inside and
outside the vehicle to avoid contact with the
locking pins and/or the vehicle structure.
10. Slightly lift the slide-out and move it outside
the vehicle on the supporting tables.
11. Take advantage of the situation to inspect
internal mechanical components, UHMW
sliding pads (section 10) and seal condition.
1.4 FRONT SLIDE-OUT
INSTALLATION
Before proceeding with the front slide-out
installation, check the following conditions:
- The air seal is completely deflated;
- The upper driving shaft pillow blocks are
loose;
- The upper and lower shaft jaw couplings are
disengaged;
- The upper and lower shaft keyless bushings
located on the driver side are tight;
- The upper and lower shaft keyless bushings
located on the motor side are free.
Note: The lower shaft keyless bushing located
near the driver seat is not accessible unless the
slide-out is removed completely from the vehicle,
and does not need to be loosened.
Caution: Ensure suspension stabilization before
using the height adjustable tables to prevent any
damage to the vehicle or slide-out structure.
1. Using height adjustable tables, raise the
slide-out and center it with the vehicle
opening.
Caution: Be careful when moving the slide-out
to prevent any damage to the slide-out itself
and/or its seal. When moving the slide-out,
check constantly its four corners from inside and
outside to avoid contact with the locking pins
and/or the vehicle structure.
2. Bring the slide-out close to the vehicle
opening. Check from inside and outside that
the four corners do not touch the vehicle
structure.
3. Carefully put the slide-out on its UHMW
sliding pads and the racks on their pinions
(figure 1 item 3 and 13). Slide the free
pinions to center them on their racks. Also,
make sure that the guide wheel is in its track
(figure 9 and figure 1 item 12).
Caution: Put soft material, such as carpet, on
the floor of the vehicle in line with the lower
racks to prevent slide-out contact when it will be
pushed inside.
4. Slowly push the slide-out inside the vehicle
keeping it straight. When the slide-out is well
seated on its racks and pinions, hold it firmly
to prevent it from falling outside or inside the
vehicle, and remove the supporting tables.
Push the slide-out inside and align the
receptacles with the locking pins.
Caution: The slide-out receptacles must be
perfectly aligned with the locking pins before
locking them.
5. Using a compressed air nozzle, lock the pins
one by one.
FIGURE
9 :
GUIDE WHEEL TRACK
6. Reinstall the upper shaft pillow block shims
in their original location (figure 8). Add or
remove shims to leave no clearance
between the pinion and the rack. Tighten the
pillow block nuts.
7. Re-engage respectively the upper and lower
shaft jaw couplings (figure 1 item 6). If
necessary, realign the right angle drive (see
section 8).
8. Tighten and synchronize the upper and
lower shaft pinion as described in section
5.6.
R3 9 May 3, 2002