PREVOST Le Mirage XL II Ultimate, Руководство по обслуживанию

Страница: 29 / 53

XL2 SLIDE-OUT SERVICE MANUAL
6. Take note of the new serial number with
revision (RV:) and version (V:) identifications
to inform Prevost service department for
controller tracking.
Caution: The new slide-out logic controller must
be programmed as described in section 13.3.4
and 13.3.5.
FIGURE
38 :
SLIDE
-
OUT BREAKERS
13.3.3 EPROM memory chip replacement
Caution: Do not leave the EPROM memory chip
installed on the wrong side for a long time. The
EPROM is installed on the wrong side when the
logic controller power LED is slightly light.
1. Remove the logic controller from the
electrical panel (13.3.2).
2. From behind the controller, unscrew the two
cover screws. Keep the screw washer
(figure 39).
3. Remove the back cover and the gasket.
4. With a small screwdriver, remove gently the
chip from its socket.
5. Install a new chip so the groove is on the
right side. Make sure each terminal is well
seated in its socket. Beware not to bend the
processor terminals. Press the chip in place.
6. Replace the gasket and the cover, and
screw them back.
7. Write the new software version (written on
the chip) on the controller sticker (if it had
changed), and inform Prevost service
department for controller tracking.
FIGURE
39 :
EPROM MEMORY CHIP LOCALIZATION
8. Reinstall the controller on the electrical
panel.
13.3.4 Rear slide-out program set-up
Caution: Never press the slide-out control
switch and the controller black push-button
simultaneously. This will change the controller
bit mode and make the controller non functional.
1. The slide-out must be retracted and all the
pins locked.
2. Trip the 4
th
breaker from the top (there are
six breakers). It will cut off the rear logic
controller electrical power (see figure 38).
3. Without starting the engine, turn the ignition
key to the "ON" position.
4. With a small screwdriver, push and hold the
logic controller black push-button and set
the 4
th
breaker (see figure 38 and figure 40).
Hold the push-button depressed until the
logic controller "OUT6" green LED goes on
(see figure 52). The green LED confirms that
the rear slide-out program is set in the logic
controller memory.
Note: If by error, the rear slide-out logic
controller program is loaded in the front slide-out
logic controller memory, it becomes necessary
to set-up the front slide-out logic controller. The
R3 29 May 3, 2002