PREVOST Le Mirage XL II Ultimate, Руководство по обслуживанию

Страница: 34 / 53

XL2 SLIDE-OUT SERVICE MANUAL
FIGURE
46 :
TOP AND BOTTOM PANEL INSTALLATION
FIGURE
47 :
TOP AND BOTTOM PANEL INSTALLATION
15. SLIDE-OUT FIXED, AWNING
AND SLIDING WINDOWS
Note: The removal and installation procedures
are based on standard service methods
described in the body section of the Prevost
maintenance manual. Refer to these procedures
for tools and adhesives specifications.
Warning: Always wear safety equipment when
working with glass and chemical adhesives.
15.1 WINDOWS REMOVAL
1. Remove the slide-out as described in
section 1.3 and 1.5.
2. If needed, remove the exterior extrusion as
described in section 12.4.4 step 3.
Caution: Be careful not to damage the adjacent
surfaces.
3. With a knife or a wire, cut the sealant and
the adhesive between the windows and the
structure. Make sure not to damage the
rubber seal between the windows.
4. With a helper, remove the window from the
slide-out.
For awning and sliding windows: unscrew
the window frame from the structure, and cut
the sealant. Remove the window.
15.2 WINDOWS INSTALLATION
Refer to procedures described in Prevost
maintenance manual. Refer to figure 48 for tape,
sealant and adhesive position.
1. Clean and prepare the windows and the
slide-out structure surfaces with appropriate
cleaner, abrasives and primers.
2. Apply appropriate double face self adhesive
tape on the slide-out structure (figure 48).
3. Apply appropriate adhesive on the slide-out
structure surfaces.
FIGURE
48 :
WINDOWS ABOVE SIDE PANELS
4. Install the windows on the slide-out. Press
the jigs on the windows and wait for the
adhesive to dry.
For awning and sliding windows: install
the window in its frame and screw it. Wait for
the adhesive to dry.
R3 34 May 3, 2002