PREVOST Le Mirage XL II Ultimate, Руководство по обслуживанию

Страница: 32 / 53

XL2 SLIDE-OUT SERVICE MANUAL
- Remove the old adhesive on the finishing
molding supports and clean them before re-
using;
-
Check where adhesive, sealant and double
face adhesive tape are on the structure and
the panel back side, in order to be able to
stick the new panel in the same way;
-
Check the tape width and use same width
tape when installing new panels.
FIGURE
43 :
SLIDE
-
OUT PANELS AND WINDOWS
14.2 SIDE PANEL INSTALLATION
For surface cleaning, and preparation, panel
installation and products needed, use the same
procedure as the MTH side panel installation
described in Prevost service manual, and:
-
Keep the slide-out retracted and all pins
locked for panel alignment;
-
Make sure to apply sealant between the side
panels and the corner panels, and also
between side panels and bottom and top
panels. Apply sealant both inside and
outside the slide-out panels.
14.3 CORNER PANELS REMOVAL
Note: The corner panels are made of aluminum,
or of stainless steel in option.
Caution: Be careful not to damage the adjacent
surfaces.
1. Remove the slide-out as described in
section 1.3 and 1.5.
2. Remove all the pin receptacles as described
in section 2.5.2.
3. Remove the fixed windows from the slide-
out as described in section 15.1.
4. Remove panel upper rivets (figure 44) and
lower rivets (figure 45) with a 1/8" drill bit, a
hammer and a punch.
5. Insert a flat screwdriver between the panel
and the slide-out structure, in the top left and
right corners of the panel, and unstick the
panel from the structure.
FIGURE
44 :
CORNER PANEL INSTALLATION
–
UPPER PART
FIGURE
45 :
CORNER PANEL INSTALLATION
–
LOWER PART
R3 32 May 3, 2002