PreView Sentry ST82 Series, Руководство по эксплуатации, Страница: 20 / 25

Tel: +386 3 4900 800 http://radar-electronics.com/
3702008A
Copyright 2016
Page 16
PreView
®
Sentry
™
Daily Maintenance
Detach this page and place with daily operator maintenance procedures.
Safety Message to Operators of Vehicles with PreView
®
Sentry
™
Systems
1. The PreView
®
Sentry
™
system is intended as an Object Detection System and
should not be relied upon as your first line of defense for the safe operation of
the vehicle. It should be used in conjunction with established safety programs
and procedures to augment the safe operation of the vehicle, ground
personnel, and adjacent property. Should the system become inoperative, it
could jeopardize the safety or lives of those who depend on the system for
safety.
2. Testing and inspection of the system in accordance with these instructions
and a record of the results should be listed on the daily maintenance report.
The units on operating vehicles must be tested each day prior to the vehicle's
operation. Results of this test must be recorded in the maintenance log.
3. People operating this equipment MUST check for proper operation at the
beginning of every shift or safety inspection period.
4. If a PreView
®
system is found to be inoperative upon test, the operator should
flag or cover the driver display and mark as “inoperative” prior to the
machine/vehicle operation.
5. People's lives depend on the proper installation of this product in conformance
with these instructions. It is necessary to read, understand, and follow all
instructions shipped with the product.
6. Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death.
7. The PreView
®
Sentry
™
is intended for commercial use. Proper installation
requires a good understanding of vehicle/machine electrical systems and
procedures, along with proficiency in the installation.
8. Store these instructions in a safe place and refer to them when maintaining
and/or reinstalling the product.
Testing and Maintenance
NOTE: A walk-around test shall be performed every day to verify proper function of
the system and to familiarize the operator with the zone of detection. More
frequent inspections should be performed when:

The vehicle is operating in a particularly dirty or harsh environment.

The operator has reason to suspect the system has been damaged.
This test should be performed with two people, one who remains in the cab (the
operator), and one who walks through the sensor detection field (the assistant).
The below example illustrates the test for a backing sensor application. Use a
similar procedure for front, side or multiple radar systems by confirming detection
of each radar sensor in the operator display.
1.
Clean the sensor face of any accumulation of dirt, mud, snow, ice, or debris.
2. Visually inspect the attached wiring and cable and verify that they are properly
secured, not chafing or dangling free where they could become snagged and
damaged. Inspect the Radar Sensor and Operator Display Module and verify
that they are securely attached to the vehicle.