PreView Sentry ST82 Series, Руководство по эксплуатации, Страница: 13 / 25

Tel: +386 3 4900 800
http://radar-electronics.com/
3702008A
Copyright 2016
Page 9
Installation
Sensor Mounting
The Sentry
™
mounting location is important for proper system operation.
Ideally the sensor should be mounted on the rear of the vehicle as close to
the center as possible at roughly 36” (1 m) above the ground. The sensor
face should be perpendicular to the ground with the small end of the “V”
graphic on the sensor face pointing down. Select a location that will
provide some protection from impact and debris while allowing an
unobstructed view of the target hazard area. Refer to the Keep
Out/Interference Zones listed in Figure 11.
Mounting Tolerances
Mounting height tolerance at 36” (1 m) should be /- 12” (0.3 m).
For optimal performance at 36” (1 m), the vertical angle (Up/Down)
tolerances are +5 degrees (up) and -2 degrees (down), and the horizontal
angle tolerance is +/- 5 degrees.
Figure 10. Vertical and Horizontal Angle Mounting Tolerances
Exceptions: if mounting higher than 4 feet (1.3 m), the sensor can be
angled down a few degrees as necessary (less than 5 degrees in most
applications).