APS901TM_RevB_12/20
3
Detailed Descriptions:
Wire Harness Colors and Func�ons
Notification Connector (4-pin connector)
See page 22 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
2. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Verification for default setting:
•
If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
•
If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
1. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default setting, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connec�on of the relay input (WHITE/RED wire).
Verification:
The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
4. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Verification:
The vehicle ground (-) source wire registers ground (-) at all �mes.
Note:
Before making this connec�on, remove all module fuses un�l the system is completely connected.
3. YELLOW/BLACK – Ignition Output to Alarm (+)
The YELLOW/BLACK wire supplies 12-Volt (+) igni�on output when the vehicle's igni�on is set to ON, but not during the
remote start run�me. This output will be used when an external alarm system is added to the vehicle.
1
3
2
4
