Prest-O-Lite 380, Инструкция по эксплуатации

Страница: 17 / 44

17
SeCTION 2 INSTAllATION
Torch comes factory installed. These instructions are for
torch replacement.
Before making any connections to the power source
output terminals, make sure that all primary input
power to the power source is deenergized (off) at the
main disconnect switch and that the input power cable
is unplugged. For operator safety, the torch connections
are loaded.
front
rear
Torch Connection
Figure 2-2. Torch Connection
2.6 SeCONDARY (OUTPUT) CONNeCTIONS
1. Connect your air supply to the inlet connection of the
filter-regulator. See Figure 2-1.
2. Thread the power cable and switch lead of the PT-31XL
through the lower left side bushing of the front panel.
Connect power cable to the torch fitting (left-hand
threads) and connect torch trigger switch leads to pins
1 and 2 of white plug located in the lower right corner
of machine. Make sure the power cable connection is
wrench-tight.
3. Replace the machine cover panel.
1. Remove the machine cover panel. The torch connection
is located on the lower side of machine. See Figure 2-2
below.
2.6.1 Torch Replacement
2.6.2 Air Connection
1. Clamp the work cable to the workpiece. Be sure the
workpiece is connected to an approved earth ground
with a properly sized ground cable. See Figures 2-3, 2-4
and 2-5.
2.6.3 Work lead Connection