PRESIDENT Grant II, Руководство пользователя

Страница: 32 / 56

32
BP Key Beep function activated
Roger Beep function activated
4) CHANNEL SELECTOR: knob and UP/DN keys of the
microphone
These switches allow increasing or decreasing a channel number. A “Beep”
sounds each time the channel changes if the KEY BEEP function is activated
( see Key Beep Function page 32 ).
5) CLARIFIER
This function allows a frequency deviation during reception in order to improve
the clearness of your correspondent’s voice.
6) F - FREQUENCY BAND SELECTION
(configuration: EU ; PL ; d ; EC ; U ; In).
The frequency bands have to be chosen according to the country of use.
Don’t use any other configuration. Some countries need a user’s licence.
See table page 53.
Proceeding:
switch off the transceiver. Keep the key
F
pressed and switch on
again.
“
ConF
” and the letter corresponding to the configuration are blinking. The
F
LED turns
on
.
- In order to change the configuration, use the channel selector or the
Up
/
DN
key on microphone (
4
).
- When the configuration is selected, press 1 second on the
F
key. “
ConF
” and
the letter corresponding to the configuration are continuously displayed, a
beep sounds. At this point, confirm the selection by switching off the trans-
ceiver and then switching it on again. See the configurations / frequency
bands table at page 49 to 51.
7) DIMMER ~ COLOR
DIMMER
(short press)
The DIMMER function allows adjusting the brightness of the lighting except
LED.
When the function is on , the DIMMER LED turns on .
COLOR
(long press)
The
COLOR
function changes the back light color orange and green. Press
COLOR
key for one second once to change the color.
8) LOCAL DX ~ KEY BEEP
LOCAL DX
(short press)
The
LOCAL DX
allows the automatic adjustment of the RF Gain for close
communication. When
LOCAL
is selected, it is adjusted RF Gain
Down
. The
LED turns
on
. When
DX
is selected, it is adjusted RF Gain
Up
. The LED turns
off
.
KEY BEEP
(long press)
Keys, changing the channel etc.
Press KEY BEEP key for one second once to enable/disable the KEY BEEP
function.
When the function is on , “BP” is displayed on the LCD.
9) MIC GAIN HI/LO
MIC GAIN HI/LO is used to adjust microphone sensitivity (MIC Gain) for trans-
mission.
When the function is on , LO is selected, it is adjusted to MIC Gain Down. The
MIC GAIN HI/LO LED turns on .
When the function is off , HI is selected, it is adjusted to MIC Gain Up. The MIC
GAIN HI/LO LED turns off .
10) MEM ~ M1 to M5
5 channels can be memorized with following parameters: AM/FM/USB/LSB
modulation mode (except for
EC
and
U
configurations); NB/ANL On/Off and
HI-CUT On/Off; CEPT/ENG Mode [Only for
U
Configuration].
To memorize:
- Select the channel and other setting that can be stored.
- Press shortly on MEM , “MEM” blinks.
- Press during one second on M1 , M2 , M3 , M4 or M5 . The store confirmation
tone sounds, “MEM” is displayed continuously and the selected memory
number blinks. The channel and other item currently selected are stored in
this memory (it becomes Memory Channel Recall Mode ).
To recall a memory:
- Press shortly on MEM , “MEM” blinks.
- Press shortly on M1 , M2 , M3 , M4 or M5 .
- “MEM” is displayed continuously. The memorized channel is active.
English