10
C
ALL
H
ANDLER
6000 I
NSTALLATION
I
NSTRUCTIONS
Caller ID Information
Caller ID information is sent by the phone company approximately
1/2 second after the first ring. Therefore, for Caller ID to work, the
answering devices must not pick up before the 2nd ring. If Caller ID
is built into the customer’s phone system, then the Caller ID will not
work because the Call Handler is blocking the Caller ID information
at this point in time If the customer has a Caller ID box that is
separate from the phone system, then that Caller ID phone inter-
face must be connected in front of the Call Handler.
Volume Adjustment on 8 ohm or 600 ohm
music-on-hold output port of Call Handler
Call into one of the phone lines and ask to be placed “on hold.”
Listen to the on-hold message and adjust the volume on the Call
Handler. Use the keypad and display on the Call Handler to change
the volume as indicated below:
Press “Setup”
Display shows: “Setup (Accept/Cancel)”
Press “Accept”
Display shows: “1 Security (Accept/Cancel)”
Press “Next”
Display shows: “2 Volume (Accept/Cancel)”
Press “Accept”
Display shows: “Volume is at XX Acc/Can
Inc/Dec”
Now press “Increase” or “Decrease” to change the output volume.
When you are done adjusting the volume;
Press “Accept”
Display shows: “2 Volume (Accept/Cancel)”
Press “Cancel”
Display shows: current Call Handler modes.
