+1 (866) 381-2785
6
Set Up the Transmitter
Important: You may need to move the transmitter several times before determining the final location.
The fence transmitter is located at the exact center of the pet area.
Place the fence transmitter:
•
At least 2 ft. above the floor located on the ground floor of
your home.
•
In a dry, well ventilated, protected area.
•
In an area where temperatures do not fall below -10°F (-23°C)
or above 140°F (40°C).
•
On a non-metal table/hard surface (to ensure proper
ventilation) or mount on a wall (
1A
). A mounting template is
included on the back of this guide.
•
At least 3 ft. from large metal objects, as these items may
reduce the size and shape of your pet area (
1B
). Placing the
transmitter inside a metal building or shed can reduce the
maximum range of the system.
• Do not place anything on top of fence transmitter or cover any
ventilation holes. This may overheat the fence transmitter and cause
early transmit failure.
• Do not place fence transmitter in a closet or any other confined,
unventilated area.
• Do not place fence transmitter on or near a metal surface.
To maximize your pet area, make sure the boundary switch/
range is on High (+) and the boundary control dial is set to 8 (
1C
).
Plug power adapter into power jack and a standard outlet. Turn
the fence transmitter on (
1D
).
Prepare the Receiver Collar
Your receiver collar comes with short contact points installed. Use the long contact
points for pets with long or thick hair. Tighten the contact points using the test light
tool (
2A
) one-half turn beyond finger tight. Check the tightness weekly.
Insert and Remove the Receiver Collar Battery
Do not install the battery while the receiver collar is on your pet.
This receiver collar utilizes a replaceable battery (GAC11-16351). This unique battery is
designed to make battery replacement easier and increase water protection.
To insert the battery, align the symbols on the battery (arrow) and receiver collar
(triangle) (
2B
). Use the edge of the test light tool (
2B
) to turn the battery clockwise
until the arrow lines up with the lock symbol on the housing.
To remove or replace the battery, turn the battery counter-clockwise using the edge
of the test light tool (
2B
). DO NOT attempt to cut into or pry open the battery. Be sure
to discard the used battery properly. When removing the old battery from the receiver
collar, discharge all power by holding the static level button down until the light is no
longer illuminated. Replace with a new battery.
Risk of explosion if batteries are replaced by an incorrect type. Do not short circuit, mix old and new
batteries, dispose of in fire, or expose to water. When batteries are stored or disposed, they must be
protected from shorting. Dispose of used batteries properly.
A replacement battery (GAC11-16351) can be found at many retailers. Contact the Customer Care Center or visit
our web site at www.premierpet.com to locate a retailer near you.
Wall
Mount
Tabletop
1A
3 ft.
1B
Power
Jack
Power
Switch
1D
BO
UND
AR
Y
CONTR
OL
7
8
8
Range Gamme
Rég
la
ge des
limit
es
1C
2A
2B
