Page 6
Installation Instructions
CTM and PSM Series Installation
PSD-TL
This stand is intended for use only with the maximum weights indicated. Use with products heavier than the
maximum weights indicated may result in instability causing possible injury.
The flat-panel is very heavy; two people are required to lift the flat-panel and secure it to the stand.
To install the mounting brackets to the flat-panel, refer to the CTM and PSM installation instructions.
Step 2
. Raise the flat-panel with the left and right brackets
secured to the flat-panel and insert the bottom and top hooks
from the mounting arms to the top and bottom rods found
on the CTM back plate.
Step 3
. Secure the mounting arms with the two (2) M6 x 12mm
Safety knobs (supplied with the CTM mount).
Step 4
. Insert and tighten two (2) M6 x 30mm lateral shift screws
(supplied with the CTM mount) on the bottom of the
mounting arms. These screws will prevent the flat panel
from moving side-to-side.
The safety knobs MUST be used. Failure to
do so may result in damage to the flat-panel or
personal injury.
CTM Back
Plate
Flat-Panel
PSD-TL Base
(facing forward)
CTM Series
Mounting Brackets
M6 x 12mm
Safety Knobs
Step 1
. For the CTM-Series, secure the back plate to
the four (4) threaded mounting points found on
the PSD-SPA with the four (4) M10 x 12 bolts
and flat washers (supplied).
The directional arrow must be pointing
up prior to installation. Secure the follow-
ing plates to the secured PSD-SPA on the
support poles.
Installing the CTM
Support Poles
PSD-SPA Adapter
Directional Arrow
CTM Back Plate
M10 x 12mm
Bolts
M10 Flat Washers
PSD-TL Base
(facing forward)
M6 x 30mm Lateral
Shift Screws
