Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 7
PP-FCTA
Pre-set four (4) M5 x 16mm combo screws on the
ceiling plate assembly (two on each end of the plate).
The M5 x 16 mm screws may be attached on the
inner or outer lip of the main ceiling plate.
®
Determine the ceiling tile you will use to attach the
ceiling adapter.
¯
Use a pencil to measure and mark 3˝ from each
edge of the t-bar frames to the inside of the tile (see
diagram).
°
Determine the mounting hole position inside the
marked square of the tile and mark it with a pencil.
If you are attaching a camera, mark an additional
hole for the 1/4”-20 screw next to the mounting
coupler.
±
Remove any of the 24˝ x 24˝ or 24˝ x 48˝ tiles that are
surrounding the marked tile.
²
Cut the mounting hole (and camera screw hole).
³
Place the ceiling plate on the t-bar rails so that the
mounting coupler can slide to align with the ceiling
mounting hole.
Mounting the PP-FCTA
Proceed to the ″Securing the Ceiling Plate″ section on
page 8.
M5 x 16mm Screws
Upper Adapter Plate
Ceiling Plate Assembly
Mounting Hole
T-Bar Frame
Ceiling Tile
3˝
3˝
3˝
3˝
1/4”-20 optional holes
