Page 10
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
1-½˝ Pipe
M5 x 16mm Screw
PP-FCTA
Loop the wire around the truss (see Figure 1).
Hang the wires from the trusses so that they will
angle 15 degrees outward from the main ceiling
plate (see Fig. 2).
®
Twist the wire at least five (5) times around itself to
secure it.
¯
Run the other end of the wire through the turnbuckle.
°
Twist the wire at least five (5) times around itself to
secure it.
±
Repeat steps 1-4 for the remaining three mounting
points.
The final loop on the wire has to be tightly bent
and secured to prevent it from untwisting. Twist
the turnbuckles to fine-tune adjust.
Recheck all hardware and installation for proper
tightness and security.
Truss Ceiling
Securing th
e
1 ½˝ NPT Pipe to the PP-FCTA
Secure the 1 ½″ NPT pipe to the mounting coupler
and tighten the pipe.
®
Secure the pipe using one (1) M5 x 16mm combo
screw to the plate.
The M5 x 16mm combo screw must be used to
stabilize the 1 ½″ NPT pipe.
¯
Attach the escutcheon ring to the 1 ½″ NPT pipe
beneath the ceiling tile.
Proceed to the ″Securing the 1 ½˝ NPT Pipe to the PP-FCTA″
section below.
Ceiling Attachment (cont’d)
Are you adding a camera to the ceiling adapter?
If
Yes,
proceed to the
“Securing the Camera
(optional)”
section on page 11.
If
No,
you have completed the ceiling adapter
installation.
15°
Figure 2
Ceiling Truss
Figure 1
