www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Installation Guide
LMVSP
Attaching the Mounting Brackets to the Flat-Panel
1)
Secure each mounting bracket to your flat-panel by inserting
a minimum of two (2) screws per bracket.
Do not overtighten the mounting hardware.
Make sure the directional arrows on the mounting
brackets are facing up.
Mounting bracket adjustments are factory pre-set (see
Note
).
This section requires two people.
Do not release your flat-panel until you are certain that top and
bottom hooks of both mounting brackets are securely seated
on the upper and lower mounting rails of the wall panel.
1)
Raise the flat-panel past the top and bottom mounting rails on the
wall panel.
2)
Slide the flat-panel down slowly, keeping it close to the wall.
3) Engage the top and bottom mounting brackets to the rails of the
mount.
Note:
These registers must
align prior to installation.
They are factory set.
Check to determine proper
alignment
Attaching the Flat-Panel to the Mount
2) Before tightening
the screws, push the bracket up to
remove slack from the bracket, then tightened the
screw.
NOTE: For smaller vesa bolt patterns, reverse the
mounting brackets.
Page 9
