GB-VESA42
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 9
Step 3
1) Place the wall plate against the wall over the
threaded shafts of the concrete wedge anchors
2) Attach the nuts and
5
/
16
″ washers to each of the
concrete wedge anchors and tighten using a socket
wrench and an M10 socket.
Do not overtighten the wedge anchor nuts.
Proceed to the
“Mounting Hardware”
section.
Installing the Wall Plate (cont’d)
Mounting Hardware
Selecting the Mounting Hardware
Small Straw
or Toothpick
Small Straw
or Toothpick
Small Straw or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
Step 4
1) Insert a concrete wedge anchor into each hole.
If necessary, lightly tap each concrete wedge anchor
into place with a hammer.
2) Remove the nuts and washers from all four (4)
concrete wedge anchors.
3) Replace the washers which you removed from the
concrete wedge anchors with the
5
/
16
″ washers shown
in the parts list on Page 3.
1) Insert the Thread Depth Indicator into the thread
inserts found on the bottom or top of the flat panel.
2) Use a pencil to mark the depth of the thread insert on
the Thread Depth Indicator, as shown in Figure1.
3) Insert the Thread Depth Indicator into the remaining
thread inserts to compare and verify their depth.
4) Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the mark
on the Thread Depth Indicator, as shown in Figure
2 and Figure 3, do not use this screw. The screw
length must not bypass the mark.
5) Test each size of the screws provided.
The correct screws should thread easily into the
mount point and not pull out when tension is
applied.
Does your flat panel have:
●
Recessed mounting points?
●
Uneven mounting points?
●
A curved back?
●
Any obstruction near the mount point?
If
Yes
, you must install Universal Spacers. Proceed to
the
“Universal Spacer Installation”
section.
If
No
, skip to the
“Flat Panel Plate Installation”
section.