GB-VESA42
Page 8
Visit the Premier Mounts website at http://www.premiermounts.com
Installation Instructions
Installing the Wall Plate (cont’d)
Use a power drill and
5
/
16
″ concrete drill bit to drill a hole at
each of the marks.
Step 1
Step 2
Step 7
1) Insert one (1)
5
/
16
″ x 3″ lag bolt and one (1)
5
/
16
″ washer
into each pilot hole.
2) Tighten all lag bolts using a socket wrench and ½″
socket.
Do not overtighten the lag bolts when attaching the
mount to the wall. Improper installation may result
in personal injury or property damage.
Proceed to the “Installing the Front Bracket” section.
The supplied
5
/
16
″ concrete wedge anchors must be
used for concrete installation.
You will need a
5
/
16
″ concrete drill bit, which is
available at your closest hardware store.
Concrete Installation
Concrete Wedge Anchors
Example of
5
/
16
″
Concrete Drill Bit (Not Included)
>12”
Two people are recommended for this step; one person
to level the wall plate and another person to mark the
mounting locations.
1) Place the wall plate against the wall in the desired viewing
location.
2) Level the wall plate.
3) Use a pencil and mark 2 upper and 2 lower mounting
locations where you will be drilling holes for the concrete
wedge anchors. Each horizontal location cannot be closer
than 12″ apart.
4) Set the wall plate to one side in a safe location.