MINI PAK’R V3
- MM2I2IN115 / MM2I2IN230
Page 4 of 21
Technical Data
The MINI PAK’R V3 air cushion system (“the machine” or “the system”) creates air cushions on-
demand for use as cushioning, protective wrap, and general transport packaging. Strict
compliance with the safety instructions are required to ensure personal safety. (See Safety
Instructions in this manual)
Specification
Film roll product
Preconfigured MINI PAK’R V3 film
Production Rate
12 meters per minute (40ft./minute)
Power Rating
Model # MM2I2IN230 – 230V, 2.5A
Mode l# MM212IN115 – 115V. 5.0A
Machine Dimensions
37cm (14.6”) wide X 36cm (14”) long X 30cm (11.8”) tall
Recommended Power Fuse
5mm X 20mm, Slow-Blow: 250V 2.5A (230V System)
5mm X 20mm, Slow-Blow: 250V 5.0A (115V System)
Machine Weight
8 kg (17.6 lbs.)
Sound pressure
< 70dbA
Safety instructions
To ensure the personal safety of operating personnel and/or users of this machine, the
instructions below must be followed at all times.
1. The machine may only be used in industrial applications. Usage in a home or office
environment is excluded.
2. The machine shall be used in a facility that is correctly ventilated for air renewal.
3. Avoid all contact with internal electrical components.
4. In case of emergency, switch off the machine and disconnect power.
5. If the machine is not used for any length of time, the Power Switch must be turned OFF
at the rear of the machine.
6. During Installation and Maintenance, the Power Switch must be in the OFF position, with
the Power Cord disconnected.
7. All safety and protection measures must be fitted and adequately maintained in
accordance with Iocal regulations.
8. Only trained and qualified service personnel may maintain any electrical and or
mechanical part of the machine.
9. During machine operation,
NEVER
touch the film at its point of entry into the machine.
Do not attempt to guide the film into the machine. Injury may result.
10. Under no circumstances may any installed safety feature be overridden.
11. After loading the Film Roll, the machine will automatically adjust to the right seal
temperature for the film. Any contact with the heating element must be avoided
(or any part in direct contact with the heating element), since it may remain hot for
several minutes after the machine has been switched OFF.