MINI PAK’R V3
- MM2I2IN115 / MM2I2IN230
Page 14 of 21
Air control
Air Control regulates the amount of air in the Air
Cushions.
If you want fuller Air Cushions, press the
+ Button
.
If you want less full Air Cushions, press the
- Button
.
Seal temperature control
The Temperature Control regulates the temperature of
the Seal unit that fuses the front and back film sheets
together.
If the Air Cushions become flat, and upon inspection the
Heat Seals are leaking air, increase the Temperature
Control by pressing the
+ Button
.
If the Air Cushions become flat because the seals are
burned through at the seal line, as evidenced by holes in
the Air Cushions, decrease the Temperature Control by
pressing the
- Button
.
NOTE: After changing the Temperature Control setting,
the MINI PAK’R V3 may take a few moments to establish
the new seal temperature. During heat-up or cool down,
the
green LED
will flash until the correct temperature has
been achieved.
If Air Cushions continue to show poor seals and produce
flat cushions, contact Pregis for assistance.
15
.0
215