Predator 61169, Руководство пользователя

Страница: 15 / 28

Page 15 For generator technical questions, please call 1-800-444-3353.
For engine technical questions, please call 1-800-520-0882.
ITEM 61169
SAFETY
Op
ERA
TION
M
AINTENANCE
SETU
p
Air Filter Element Maintenance
1. Remove the Access Panel on the
side of the Generator.
2. Remove the Air Cleaner Cover and the
air filter elements and check for dirt.
Clean or replace as described below.
3.
Cleaning:
• For “paper” filter elements:
To prevent injury from dust and debris,
wear ANSI-approved safety goggles,
NIOSH-approved dust mask/respirator, and
heavy-duty work gloves. In a well-ventilated
area away from bystanders, use pressurized
air to blow dust out of the air filter.
If this does not get the filter clean, replace it.
• For foam filter elements:
Wash the element in warm water and
mild detergent several times. Rinse.
Squeeze out excess water and allow it to dry
completely. Soak the filter in lightweight oil
briefly, then squeeze out the excess oil.
4. Install the new filter or the cleaned filter.
5. Secure the Air Cleaner Cover and
replace the Access Panel before use.
Spark plug Maintenance
1. Remove Access Panel from top
of Generator, see above.
2. Disconnect spark plug cap from end of plug.
Clean out debris from around spark plug.
3. Using a spark plug wrench, remove the spark plug.
4. Inspect the spark plug:
If the electrode is oily, clean it using a clean, dry rag.
If the electrode has deposits on it, polish it using
emery paper. If the white insulator is cracked or
chipped, the spark plug needs to be replaced.
NOTICE:
Use only A7RTC type spark plug. Using
an incorrect spark plug may damage the engine.
5. When installing a new spark plug,
adjust the plug’s gap to the specification on the
Specifications chart. Do not pry against the
electrode, the spark plug can be damaged.
6. Install the new spark plug or
the cleaned spark plug into the engine.
•
Gasket-style :
Finger-tighten until the gasket
contacts the cylinder head,
then tighten about 1/2-2/3 turn more.
• Non-gasket-style :
Finger-tighten until the plug
contacts the cylinder head,
then tighten about 1/16 turn more.
NOTICE: Tighten the spark plug properly.
If loose , the spark plug will cause the
engine to overheat.
If overtightened , the threads in the
engine block will be damaged.
7. Apply dielectric spark plug boot protector
(not included) to the end of the spark plug
and reattach the wire securely.
8. Replace Access Panel.