a. Auto-cal the bike:
l
Set the resistance to minimum.
l
Start pedaling the bike at 55 rpm or greater, then slow down and allow
the pedals to stop. When the flywheel stops, the bike will perform the
power measurement AutoCal. Wait a minimum of 10 seconds for the
AutoCal to complete.
IMPORTANT
: The resistance knob must be set to the minimum resistance level to
correctly perform the AutoCal function. The WATTS parameter will be incorrectly
computed if the resistance knob is not set to minimum resistance level during
AutoCal.
b. Verify the measured WATTS at minimum and maximum resistance levels:
l
Set the resistance to minimum.
l
Start pedaling and maintain the speed at 60 rpm as reported on the con-
sole
RPM
. While continuously pedaling, verify the measured
WATTS
is
within spec at the minimum and maximum resistance levels. Continu-
ously pedal between measurements.
Resistance
Level
Power (WATTS)
minimum
≤ 40 Watts @ 60 rpm
maximum
≥ 415 Watts @ 60 rpm
Power (WATTS) specification
IMPORTANT
: The bike must be AutoCal'd before making the WATTS meas-
urement. Also, the bike must be continuously pedaled between the min and max res-
istance WATTS measurements. If the pedals stop, a new AutoCal may occur
invalidating the measurements.
9. While riding the bike at 60 rpm, stop pedaling and firmly press down the resistance
knob. Verify that the flywheel immediately slows down and stops rotating.
10. Verify the bike operation per
"Operation Verification Checklist" on page 14
and return
to service.
See Also
"Adjustment Procedures" on page 17
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 26
4 Adjustment Procedures
Brake Pad Adjustment
