PRECISION DIGITAL Helios PD2-6200, Инструкция по эксплуатации

Страница: 42 / 53

Helios PD2-6200 Analog Input Flow Rate/Totalizer
Instruction Manual
42
Advanced Features Menu
To simplify the setup process, functions not needed
for most applications are located in the
Advanced
Features menu.
Press and hold the Menu button for three seconds to
access the advanced features of the meter.
Advanced Features Menu &
Display Messages
The following table shows the functions and
messages of the
Advanced Features menu in the
order they appear in the menu.
Advanced Features Menu & Display Messages
Display Parameter Action/Setting
filter
Filter Set noise filter value
bypASs
Bypass Set filter bypass value
Round
Round Set the rounding value for
display variables
seriAl
Serial Set serial communication
parameters
SlaV Id
Slave ID Set slave ID or meter
address
baud
Baud rate Select baud rate
Tr dLY
Transmit delay Set transmit delay for serial
communication
Parity
Parity Select parity
Even, Odd, or None with 1
or 2 stop bits
t-byt
Time byte Set byte-to-byte timeout
SelEct
Select Enter the Select menu
(function, cutoff, out)
Functn
Input signal
conditioning Select linear, square root,
programmable exponent,
or round horizontal tank
function
Linear
Linear Set meter for linear
function and select number
of linearization points
No PtS
Number of
points Set meter for 2 to
32-point linearization
Square
Square root Set meter for square root
extraction
Prog E
Programmable
exponent Set meter for
programmable exponent
and enter exponent value
Advanced Features Menu & Display Messages
Display Parameter Action/Setting
rht
Round
horizontal tank Set meter for round
horizontal tank volume
calculation
Inch
Dimension
(cm) Calculate volume in
gallons or meters
dianmr
Diameter
Enter the tank’s diameter
in inches
Length
Length
Enter the tank’s length in
inches
CutofF
Cutoff Set low-flow cutoff
Count
Count Set total and grand total
count direction
Tot C
Total Count Set total to count up or
down
Gtot C
Grand Total
Count Set grand total to count up
or down
C Strt
Count Start Set start for total or grand
total countdown
AoutPr
Analog output
programming Program analog output
parameters
Source
Source Select source for the
4-20 mA output
O-rang
Overrange Program mA output for
display overrange
u-rang
Underrange Program mA output for
display underrange
Break
Loop Break Set relay condition if loop
break detected
Force
Force Force analog output value
for loop break
Ignore
Ignore Ignore loop break condition
nmAx
Maximum Program maximum mA
output allowed
nmin
Minimum Program minimum mA
output allowed
Calib
Calibrate Calibrate 4-20 mA output
(internal reference source
used for scaling the output)
4 nmA
4 mA output Enter mA output value
read by milliamp meter
with at least 0.001 mA
resolution
20 nmA
20 mA output Enter mA output value
read by milliamp meter
with at least 0.001 mA
resolution
user
User I/O Assign function keys and
digital I/O
F1
F1 function key Assign F1 function key
F2
F2 function key Assign F2 function key
F3
F3 function key Assign F3 function key
F4
F4 function Assign F4 function (digital
input)
dI I
Digital input 1 Assign digital input 1-4
dO 1
Digital output 1 Assign digital output 1-4
ICal
Internal source
calibration Enter internal source
calibration (used for
scaling the meter without a
signal source