EASYBKW
ENGLISH
ISEASYBKW_06_17
.docx
18
10. Return to Factory Default Settings
Warning: You must be very careful before using this command!
Doing so will erase the entire memory which includes all User and
Special Codes, and return all codes to their factory default
settings.
1) Enter Programming Mode.
2) Press "0" to enter Menu 0
The Transmit LED will
flash red
The Program LED will flash red
3) Enter your 4-digit Programming Code
If the Programming Code is
valid, all memory will be
erased, you will hear three
beeps and the controller will
return to Normal Mode.
If the Programming Code is invalid you will hear a long
beep and the controller will return to Normal Mode
without erasing the memory of the controller.
11. Replacing a lost Programming Code
In the event that the Programming Code is forgotten, the EASYBKW
may be reprogrammed in the field using the following instructions:
1) Remove power from the reader
2) Activate tamper by removing the reader from the wall or
removing the reader’s case.
3) Apply power to the reader
4) You now have 10 seconds to enter Programming Mode using
the factory default Programming Code 1234.
GREEN
