Praher Plastics AQUASTAR mp6 plc, Руководство по эксплуатации

Страница: 30 / 44

www.praherplastics.com 10
If a voltage is applied to an input of the Aquastar for a minimal time of 2 seconds the
corresponding position is approached.
If however a voltage is applied to more than 1 input a corresponding error is signalled and the
Aquastar approaches the position filter.
This error can be reset by not applying voltage to any input and setting a new position as
described above.
If the Aquastar is in the errorstate it can be reset to normal operation by applying a voltage to
either ERR or FI,BW and RI simultaneously for at least 5 seconds and taking it away after that.
Before an error is reset the cause of the error should be checked to avoid damaging the
device.
10.4 Operation with SafetyPack
If the Aquastar is used with a SafetyPack the power supply has to be 24VAC/DC or 24 VDC
when it is driven by the PLC power supply.
If the Aquastar is driven by the 100-230VAC power supply however, no adjustments have to
be done.
Additionally the Aquastar has to be connected to the blue SafetyPack connector and to the
accumulator in the cap of the Aquastar.

Aquastar Safetypack manual
10.5 Technical data
Power: 1.5
– 2“ version 20VA
3“ version 30VA
Max. allowed voltage without 230V power supply:
34VDC +10%
24VAC +10%
Max. allowed voltage with 230V power supply:
10%
(look at 13.2)
Rated operating current:
0.7 / 1A rms at 24V AC
0,5 / 0,7A rms at 24V DC
70 / 120mA rms at 230V AC