practyl 819880, Руководство по сборке, использованию и обслуживанию

Страница: 79 / 86

157 156
EN EN
hole cutting centre to the guide fence rod still fitted to the radius of the hole
required from the centre of the hole to the outer edge of the cutter. Spot drill a
suitable size hole in the work piece at the required centre point and locate the hole
cutting centre into the predrilled hole. The router will now pivot on the hole cutting
centre. If a disc is required follow the above procedure but measure the radius of
the disc required from the centre of the hole cutting centre, to the inner edge of
the cutter.
The size of the template will be determined by the size of the cutter to be used.
With the guide bush and a router cutter fitted measure the distance from the
outer edge of the guide bush to the edge of the cutter. For internal templates
the template will need to be larger by this amount than the profile to be cut. For
external templates the template will need to be smaller by this amount than the
profile to be cut.
With the thumbwheel, the required speed can be selected (also while running).
6.8 Using the hole cutting attachment
6.9 Template sizing (Fig.22-23)
6.10 Speed adjuster
Min-2 Low speed
3-4 Medium speed
5-Max High speed
The values shown in the chart are standard values. The necessary speed depends
on the material and the operating conditions, and can be determined by practical
testing.
After longer periods of working at low speed, allow the machine to cool by running
for approx.3 minutes at maximum speed with no load.
Speed stages
5-Max.
3-4
Min.-2
5-Max.
3-4
Min.-3
3-Max.
2-4
Min.-3
2-3
Min.-2
Router
4-10mm
12-20mm
22-40mm
4-10mm
12-20mm
22-40mm
4-10mm
12-20mm
22-40mm
4-15mm
16-40mm
Material
Hardwood(Beech)
Softwood (Pine)
Particle board
Plastic
The machine does not require any special maintenance.
If the carbon brushes need to be replaced, have this done by a qualified repair
person (always replace the two brushes at the same time).
If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
Cleaning
Avoid using solvents when cleaning plastic parts.Most plastic parts are susceptible
to damage from various types of
commercial solvents and may be damaged by their use.Use clean cloths to remove
dirt,car bon dust.etc.
Lubrication
All the bearings in this tool are lubricated with suffident amout of high grade
lubricant for the life of the unit under
normal operationg conditions,therefore no further lubrication is required.
7. CLEANING AND MAINETENANCE