practyl 819880, Руководство по сборке, использованию и обслуживанию

Страница: 78 / 86

155 154
6.3 Stopping and starting
6.4 Variable speed
This router is fitted with a safety button to prevent accidental starting. Hold the
router firmly with both hands on the grips. Use your thumb to press in the safety
button (14.1) then squeeze the On/Off switch (14.2) and hold. To stop the machine,
just simply release the switch.
Located at the front right of the machine is the variable speed dial (15.1) simply
rotate the dial to increase or decrease the speed. The smaller the router bit the
faster the speed. The larger the router bit the slower the speed. A router bit that is
rotating too fast will scorch the work piece leaving a burn mark.
6.5 Using the parallel fence
The parallel guide can be used to make a cut at a parallel distances from the edge
of the work piece Slide the parallel fence into the base of the router and set the
desired distance from the cutter to the fence. Secure the fence in place with the
two locking knobs. Hold the fence securely against the edge of the work piece and
In order to avoid it chatter and to obtain the best results, cuts need to be made in
an anti-clockwise direction for external cuts and a clockwise direction for internal
cuts.
Warning:
Isolate the machine from the power supply before any adjustments,
maintenance or when changing router bits.
If the carbon brushes need to be replaced, have this done by a qualified
repairperson (always replace the two brushes at the same time).
If the performance of your router is poor or there is excessive sparking visible
through vents on top of the machine the carbon brushes need replacing. Remove
the four cross head screws that secure the brush cover. Carefully remove the cover.
Locate the brushes (one each side) and lift upwards and outwards (19.1).Be careful
not to disturb any wiring. Hold the black outer casing (20.1) and remove the spring
loaded carbon brush
(20.2)Always replace in pairs obtainable from your stockist. Re-fit the carbon
brushes and place them back into position. Repeat operation for other side. Ensure
that the machines ventilation slots are kept clear of sawdust/chippings etc. Keep
plunge guides clean and lubricated with a light multi purpose oil. There are no
other user serviceable parts in this unit
6.6 Direction of cut
6.7 Replacing carbon brushes
perform the operation.
EN EN