PPE Stage 4, Руководство по установке

Страница: 6 / 16

Stage5 Installation Guide
6
Discard original trim valves and the springs from the small end of the valves.
Place new ball bearings the small spring into the hollow end of the new trim
valves. Use transmission gel (or petrolium jelly) to hold ball bearing in place. In -
sert new outer springs over the small end of the trim valves. Install the assembly
into the Valve Body. Don’t force them, a little wiggle and they will drop in. Install
outer spring, solenoid valves and solenoids as shown. Outer spring must be
installed in the “A” Line up.
Step 9
Valve
A line up
B line up
Bell housing - Front View
Stator
With the bell housing off the trans, remove 10 bolts in the bell housing, these
bolts have O-Rings under bolt heads.
Step 10
Remove 5 bolts from rear. Lift off
stator and flip it over.
Step 11
Replace Trim Valves
Valve A
has rib