Powersmart PS8213, Инструкция по эксплуатации, Страница: 13 / 18

13
CUTTING INSTRUCTIONS
Basic cutting procedure
Wear non-slip gloves for maximum grip and protection.
For the best cutting action against walls, fences and in high grass, move trimmer slowly so grass is cut
WITH THE TIP of the high speed nylon line.
Avoid running trimmer with hub in contact with ground. Trim only when grass and weeds are dry.
NOTE: As the weather becomes cooler, the tendency for the nylon line to break becomes greater. DO
NOT USE WHEN TEMPERATURE IS BELOW 50 degrees F.
Cut tall grass from top down. Hold the trimmer with your right hand on the rear handle and your left
hand on the front handle. Trimmer should be held at a comfortable position with the rear handle about hip
height.
WARNING: Always hold trimmer away from body. Any contact with the string trimmer
cutting head while operating can result in serious personal injury.
WARNING:
Do not trim near electrical wires.
WARNING:
Do not operate a string trimmer in a tree, on a ladder, or on a scaffold; this is
extremely dangerous.
Trimming instructions

Angle unit as shown (See fig.5).

Slowly swing trimmer side to side as shown (See fig.6).

To convert for maintenance edging, turn off the tool.
Unplug the string trimmer. Pull up shaft locking collar
and turn handle end counterclockwise. Release edging
shaft locking collar when handle has been rotated 180°
and locks into place (See fig.7).

Rotate the wire edge guide forward and down into place
before edging.

To operate as a maintenance edger, position trimmer
above sidewalk as shown (See fig.8).

Return to trimming position by turning the tool off, push
in direction of arrow and rotate the trimmer head counter
clockwise until it stops. When using the tool in the
trimmer mode you may choose to fold the wire edge
guide up out of the way.
Advancing lines
NOTE: The trimmer is equipped with an auto-feed head. Bumping the head to try to advance the line will
damage trimmer and void warranty.

With the trimmer running, release the switch trigger.

Wait two seconds, and press the switch trigger.
NOTE: The line will extend approximately 1/4 in. with each stop and start of the switch trigger until
the line reaches the length of the grass deflector blade.

Resume trimming.
Fig.5
Fig.6
Fig.7
Fig.8