Powersmart PS6300, Инструкция по эксплуатации

Страница: 15 / 27

15
PRIMING AND STARTUP STEPS
1. Separate smaller Priming Tube from Suction
Tube.
2. Place Priming Tube in waste bucket.
3. Submerge Suction Tube in water or flushing
solvent.
4. Turn Prime/Spray switch to Prime mode.
5. Adjust Pressure Control Knob to Prime/Clean
setting.
6. Plug in Sprayer and turn on power.
7. Sprayer will start pumping and water or
flushing solvent as well as air bubbles will be
purged from system. Let fluids discharge from
Priming Tube into waste bucket for 30 to 60
seconds then switch Power to Off.
8. Remove Suction Tube from water or flushing
solvent and submerge in paint pail.
9. Switch Power to On.
10. Paint should work itself from Suction Tube to
Sprayer to Return Tube until paint discharges
from Return Tube. Point gun into waste bucket
and pull trigger.
11. Turn spray/prime switch to spray mode and
continue to spray into waste bucket.