Powersmart DB7126PA, Инструкция по эксплуатации

Страница: 17 / 32

17
STOPPING
When finished using your Snow Thrower, perform the following steps to shut it down.
1.
Engage the auger and impeller for 30 seconds to clear any remaining snow inside your Snow
Thrower.
2. Stop the auger by releasing the left control handle.
3. Set the engine switch to the OFF position. See ENGINE manual for stopping procedures.
4. Remove snow from all Snow Thrower surfaces including the auger housing and chute areas.
CLEARING RESTRICTIONS
If the snow discharge chute or auger housing becomes clogged STOP the engine, and make sure that all
rotating parts have come to a complete stop.
Use the supplied snow clean out tool to clear the obstruction. After unclogging, wipe the tool clean, and
place it in the holder on top of the auger housing.
MAINTENANCE
WARNING! Never perform maintenance while your Snow Thrower is running. Turn OFF the engine
before performing any maintenance tasks on your Snow Thrower.
Proper maintenance of your Snow Thrower will help prolong its life. Please perform the following
maintenance procedures as required.
Please read the ENGINE manual for engine maintenance procedures.
Do not attempt to repair your Snow Thrower unless you have the proper tools and instructions for
disassembly and repair.
Check the bolts at frequent intervals for proper tightness to ensure that the equipment is in safe working
condition.
After each snow removal session, run the Snow Thrower for a few minutes to prevent the collector
/impeller from freezing. Stop the engine, wait for all revolving parts to stop completely, and wipe residual
ice and snow off the unit. Rotate the chute rotation handle several times to remove any excess snow.
MAINTENANCE PROCEDURES
TIRE INFLATION
Before each use of your Snow Thrower, check the tire pressure. The pressure in each tire should be in the
range of 20-24 psi for the best performance. The pressure can be checked using an ordinary tire pressure
gauge. Fill the tires using a small or pressure regulated air compressor.
WARNING! DO NOT OVER-INFLATE THE TIRES. Over-inflating could cause a tire to burst and
cause severe bodily injury.