Powersmart DB7126PA, Инструкция по эксплуатации

Страница: 12 / 32

12
ASSEMBLY AND ADJUSTMENTS
The following section describes steps necessary to prepare the snow thrower for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the snow thrower or
shorten its life.
Unpacking
Unpack the snow thrower and all its parts, and compare against the list below.
1. Snow Thrower
2. Discharge Chute Assembly
3. Lower Handle
4. Chute Rotation Handle
5. One Pair of Skid Shoes with hardware
6. 4 Extra Shear Pins and Locknuts
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before using your
Snow Thrower.
WARNING: This snow thrower is heavy. Assembly procedures may require lifting
equipment or two people.
Step 1 – Handle assembly
1. Attach the lower handle using four (4) bolts. Each side will require
two (2) bolts. Make sure the “UP” label on the lower handle to face
up.
2. Attached the upper handle to the lower handle using (4) knobs,
washers and bolts.
NOTICE: Do not bend or kink the control cables. The cables should be routed under the handle
assembly and not wrapped around the handle or knobs. The cables must move freely and not bind.
Bolt
Knob, Washer and Bolt