POWXG1018
EN
Copyright © 2015 VARO
P a g e
|
10
www.varo.com
9.2
Mixing fuel
Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to
mix with oil. Shake container to ensure thorough mix.
Warning: Lack of lubrication voids engine warranty. Gasoline and oil must
be mixed at 25:1
9.2.1
Fuel and lubrication symbols
9.2.2
Fuel mixing table
Gasoline liters
1
2
3
4
5
2-cycle oil ml
40
80
120
160
200
9.2.3
Recommended fuels
Some conventional gasolines are being blended with oxygenates such as alcohol or an ether
compound to meet clean air standards. The engine is designed to operate satisfactorily on any
gasoline intended for automotive use including oxygenated gasolines.
9.2.4
Chain and bar lubrication
Always refill the chain oil tank each time the fuel tank is refilled. We recommend using our
replacement chain & bar. Always use good quality sprocket oil, which contains additives to
reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain
10 OPERATION
10.1
Engine pre start checks
WARNING: Never start or operate the saw unless the bar and chain are
properly installed.
Fill the fuel tank (A) with correct fuel mixture.
Fill the oil tank (B) with correct chain and bar oil.
Be certain the chain brake (C) is disengaged before starting unit.
10.2
To start engine
To start the saw, push the switch (ON/OFF switch) to the ON (I) position. (Fig. 9a)
Pull out the choke (A) to the point where it latches in place. (Fig. 9b)
Depress starter switch and (C) safety trigger (D) release trigger and then the latch. (Fig.
9c)
