Powerplus POWXG1018, Руководство пользователя

Страница: 11 / 22

POWXG1018
EN
Copyright © 2015 VARO
P a g e | 11
www.varo.com

Place the saw on a firm and level surface. Hold the saw securely with your foot as
illustrated. Tug sharply on the starter 2 times. Watch the chain in case it runs. (Fig. 9d)

When engine turns, choke will automatically switch off. (Fig. 9e)

Let the engine run for 10 seconds to warm up. Press the trigger (H) and put it into idle.
(Fig. 9f)

If the engine does not start up, repeat the above steps.
10.3 Re-starting a warm engine

Make sure the on/off switch is i
n the “I” position.

Pull the starter rope rapidly 2 times. The engine should start.
10.4 To stop engine

Release trigger and allow engine to return to idle speed.

Push the I/O (on/off) switch to o (off) to stop engine.
Note: for emergency stopping, simply activate chain brake and switch the
I/O (on/off) switch to o (off).
10.5 Chain brake operational test
Test the chain brake periodically to ensure proper function.
Perform a chain brake test prior to initial cutting, following extensive cutting, and definitely
following any chain brake service.
Test chain brake as follows:

Place saw on a clear, firm, flat surface.

Start engine.

Grasp the rear handle (A) with your right hand (fig. 10).

With your left hand, hold the front handle (B) [not chain brake lever (C)] firmly (fig. 10).

Squeeze the throttle trigger to 1/3 throttle, then immediately activate the chain brake lever
(C) (fig. 10).
Warning: activate the chain brake slowly and deliberately. Keep the chain
from touching anything; don t let the saw tip forward.

Chain should stop abruptly. When it does, immediately release the throttle trigger.
Warning: if chain does not stop, turn engine off and take your unit to the
nearest authorized service center for service.

If chain brake functions properly, turn the engine off and return the chain brake to the
disengaged position.
Warning: if chain does not stop, turn engine off and take your unit to the
nearest authorized service center for service.
10.6 Saw chain / bar lubrication
Adequate lubrication of the saw chain is essential at all times to minimize friction with the
guide bar. Never starve the bar and chain of oil. Running the saw with too little oil will
decrease cutting efficiency, shorten saw chain life, cause rapid dulling of chain, and cause
excessive wear of bar from overheating. Too little oil is evidenced by smoke, bar discoloration
or pitch build-up.