Powernail 445FS, Руководство по эксплуатации и обслуживанию

Страница: 4 / 16

ADAPTER FOOT
LOCATING EAR
Figure 2.
Figure 3.
Set the nailer on a sample of your fl ooring.
Raise the nailer foot above the tongue
to line up the nail pocket.
4
FLEX Foot Adjustment:
Wood varies from one manufacturer to the next.
The diff erent wood profi les may be due to height
and length of the fl ooring tongue and whether or
not there is a nail pocket.
First, loosen the two hex bolts under the FLEX
foot with the Allen Wrench supplied with the nailer.
(Figure 1.)
Next, set the nailer on a sample of your fl ooring
(see Figure 2).
Use the adjustment lever at the back of the nailer
foot to raise or lower the nailer to the wood. Match
the Adapter Foot Locating Ear so that it is pointing
into the 90° angle created by the tongue and the
top of the wood (see Figure 3). For wood with a
nail pocket, line up the Locating Ear so at the top
of the nail pocket.
When the adjustment lever is in the correct position
for your wood sample, tighten the two hex bolts to
lock the FLEX foot into place.
Always check your adjustment with a sample to
ensure the staple is driving into the nail pocket.
OPERATING INSTRUCTIONS
1. Loosen 2 hex screws.
2. Raise or lower the FLEX to your wood sample.
3. Match the Locating Ear to the nail pocket.
4. Tighten 2 hex screws.
5. Test wood sample with new adjustment.
Hex Allen Wrench
FLEX
Adjustment Lever
Figure 1.
To Load the Powernail Flex:
Place up to one stick (100) of Powercleats® (18 gage)
nails, 1" , 1-1/4" , 1-1/2" or 1-3/4" long into the nail
channel feed slot. Pull back the spring loaded nail
pusher over the nails until it contacts the last nail and
slowly release the nail pusher.
To Unload
To remove nails from the nail channel, pull the two
round knobs on the nail pusher together. This will clear
it from the nail path. Then turn the nailer over so the
nails slide out of the channel.
To use the Model 445FS Power Roller, adjust the
stapler's FLEX foot to a sample of your fl ooring
(Figure 1). When the FLEX foot is adjusted to your
fl ooring, simply place the stapler on the fl oor and pull
the stapler back so the locating ears catch the edge
of the fl oor aove the tongue. Pull the safety trigger
and tap the plunger with the rubber-capped mallet
tolet the stapler drive and set the nail at the correct
45° angle. The Power Roller is designed to nail
from left-to-right. Consult the fl ooring manufacturers
recommended nailing schedule.