Powernail 445FS, Руководство по эксплуатации и обслуживанию

Страница: 3 / 16

3
SAFETY INSTRUCTIONS
Always use approved SAFETY GLASSES and EAR PROTECTION when operating this stapler. The
operator and others in the work area should always wear approved FRONT and SIDE eye protection
when operating this stapler. Eye protection will help guard against fl ying staples and debris, which could
cause severe eye injury.
EYE AND EAR PROTECTION should be used to prevent hearing damage when there are high noise
levels in the work area.
ALWAYS use ear plugs with a noise reduction rated at 29 db or highter at a construction site.
Stapler noise ratings are at LPA-1sd=90.6,
LWA-1sd=99.3 and LPA-1s,1m=86.3.
Stapler vibration rating: m/s2=3.05.
Always DISCONNECT THE AIR SUPPLY before making any adjustments, repairing, clearing jams or when the
stapler is not in use. Do not use on scaff olding or ladders and disconnect stapler from air supply when transporting
between installation areas.
Never attach the female end of a quick disconnect to the stapler. This will trap air inside the Stapler and permit it to
be discharged. Only the unrestricted male connection should be attached to the Stapler.
Stapler requires an air source that can continuously deliver 80 to 110 psi at 3-1/2 cubic feet of air per minute for
operation.
Normal air pressure should not exceed 120 psi or damage to the Stapler and seals may occur. Excess air
pressure can cause the Stapler to explode.
To prevent fi re or explosion, use only regulated compressed air—do not use bottled gases of any kind (no oxygen
or combustible gasses) to power this Stapler.
Stapler is intended for use installing wood fl ooring and is not to be used for purposes not specifi ed in the
operations manual.
The trigger is a safety device and should only be pulled when the Stapler is in proper Position on the work surface
and before the plunger is struck with the mallet. Do not tie or tape down the safety trigger as the Stapler could
discharge if dropped on the plunger. The Stapler will not fi re unless the trigger is pulled before the mallet blow. Do
not use the trigger safety as a lock up for the plunger then rack the wood using the locked up Stapler body. It will
severely damage the Mechanism and the Stapler. Use the mallet to rack the wood strip, not the Stapler.
Do not use any nails other than Powernail Powercleats Nails which are specifi cally designed for use in any
Powerstapler. Powercleats Nails are available in various lengths. Contact your Powernail Dealer for Powercleats
Nails.
Use only Powernail replacement parts in the repair or maintenance of this stapler. Parts or repair services are
available from the manufacturer or from agents authorised by the manufacturer. Repairs should be carried out
only by trained service personel in the fi eld of fastener driving tools who will observe proper safety controls while
performing maintenace. Service personel should be qualifi ed to to asses the safe working condition of fastener
driving tools.
Never place any part of the body in the discharge path of the Stapler when air is connected to the
Stapler. Always make sure Stapler is empty of cleats before connecting air hose so as to prevent any
accidental discharge from occurring.
Never leave the Stapler unattended while it is connected to an air supply.
Whenever air is connected to the Stapler, keep body parts away from the nail discharge path. Disconnect the air
line before making adjustments or repairs on the Stapler. Only connect air to an unloaded Stapler so as to prevent
accidental discharge.
POWERNAIL COMPANY, INC.
1300 Rose Road, Lake Zurich, IL 60047 US
Phone: 1-800-323-1653 OR 847-847-3000
www.powernail.com