www.powermaxfitness.net
15
3.
Running belt tension adjustment
All treadmills’ belts should be adjusted before leaving the factory and after the
installation, however, after it is used for a period, looseness may occur. For example: when
users are running, it may occur pause and slip, if which happens, adjust the belt and bolts
synchronously from both the left and right side in a clockwise direction and with semicircle
as the unit; if the running belt is too loose, it may occur slip between the belt and the roller
when treading on the belt; but if too tight, it will be easy to increase the motor load and
damage motor, running belt, roller, etc.
4.
Running belt deviation adjustment
All treadmills’ belts should be adjusted before leaving the factory and after the
installation, however, after it is used for a period, it may occur belt deviation, which is
caused by the following reasons:
•
The main engine is not placed evenly.
•
The user’s feet are not on the centre of running belt.
If the deviation phenomenon is caused by the uneven force of the user’s feet, no-load
rotation for a few minutes can make it normal. For deviation phenomenon that can’t
return to normal automatically, adjust step by step by using 6MM inner hexagon spanner
with the machine and with quarter-circle as the unit. Running belt deviation is not covered
in the warranty scope and is mainly maintained by users according to the instruction book.
Deviation phenomenon will severely damage the running belt, so it should be found and
corrected in time.
5.
Driving belt adjustment
All the treadmills’ driving belts are adjusted before leaving the
factory, but after using for a period, it may still occur slip, which
is mainly adjusted by users. Adjustment steps (see the picture):
•
Clockwise rotate adjustment screw with spanner.
•
Adjustment scope is subject to no slip when loading.
如果跑带左偏,则顺时针调节左
边螺丝或逆时针调节右边螺丝
如果跑带右偏,则顺时针调节右
边螺丝或逆时针调节左边螺丝
If deviate to the right, then
adjust the screw on the right side
clockwise or the screw on the left
side anticlockwise.
If deviate to the left, then adjust
the screw on the left side clockwise
or the screw on the right side
anticlockwise.