www.powermaxfitness.net
9
3. INSTALLATION STEPS
When installing, first simply fix all the screws, and then tighten up after the shelf has been
installed.
Step1
Step 2
Step 3: (only for multifunction)
Electronic watch and hand grip Tighten up the hand
grips on both sides with M8*20 screw separately by
making them pass through handgrip hole and
connected with
The uprights.
up and down U-shaped tube
First place the rubber protection sleeve at each side
of U-shaped tube, assembly 2 ends of U-shaped tube
to iron plate of left and right stand column with
M8*40 screws, lock with nuts (special attention, the
middle screw hole of U-shaped tube point to the
bevelled-up direction, U-tube should not trap the L
iron. Put on the above it's approved. Down U-tube
with foam, and upper without it) see on the right
picture
Upright:
1. Uplift part of the upright and electronic watch dial,
use one M8*45 screw respectively on both sides of the
treadmill to pass through the below connection hole,
add the shims and tighten up the screws.
2. Tighten up the two uprights with two M8*20 Screw.
