Powermatic 1150HD, Инструкция по эксплуатации

Страница: 4 / 44

4
As with all machines, there is a certain amount of hazard involved with the use of this drill press. Use the
machine with the respect and caution demanded where safety precautions are concerned. When normal safety
precautions are overlooked or ignored, personal injury to the operator can result.
Read, understand and follow the safety and operating instructions found in this manual. Know the limitations
and hazards associated with an 1150A or 1150HD Drill Press.
Electrical grounding. Make certain that the machine frame is electrically grounded and that a grounding lead is
included in the incoming electrical service. In cases where a cord and plug are used, make certain that the
grounding lug connects to a suitable ground. Follow the grounding procedure indicated by the National Electric
Code.
Eye Safety. Wear an approved safety face shield, goggles or glasses to protect eyes. (NOTE: Common
eyeglasses are not safety glasses.)
Personal Protection. Before operating the machine, remove tie, rings, watch and other jewelry and roll up
sleeves above the elbow. Remove all loose outer clothing and confine long hair. Protective type footwear should
be worn. Where the noise exceeds the level of exposure allowed in Section 1910.95 of the OSHA regulations,
use hearing protective devices. Do not wear gloves.
Work Area. Keep the floor around the machine clean and free of tools, tooling, stock scrap and other foreign
material, and oil, grease or coolant to minimize the danger of tripping or slipping. Be sure the table is free of
chips, tools and everything else not required for the task to be performed. Powermatic recommends the use of
anti-skid floor strips on the floor area where the operator normally stands and that each machine's work area be
marked off. Make certain the work area is well lighted and ventilated. Provide for adequate work space around
the machine.
Guards. Keep all machine guards in place at all times when the machine is in use. Do not operate the machine
with the guard off.
Operator Position. Maintain a balanced stance and keep your body under control at all times. Do not over-
reach.
Careless Acts: Give the work you are doing your undivided attention. Looking around, carrying on a conversa-
tion, and "horseplay" are careless acts that can result in serious injury.
Maintain Tools in Top Condition. Keep tools sharp and clean for safe and best performance. Dull tools can
increase the feed force required and can result in burning the stock or seizing up, causing the work to be pulled
free from its holding device. Dull or improperly sharpened drills will not produce a straight hole.
Use the Proper Speed and Feed. Tables are provided on pages 17-20 as a guide in selecting the correct speed
and feed rate for a variety of materials. For materials not shown, consult the material supplier for correct speed
and feed rate. Adjust speed on variable speed models only with the power on. On step cone models, make sure
power is off and the spindle has come to a complete stop before opening the access door to change speeds.
Never Drill Freehand. Always block or clamp the work piece. A drill bit or tap can seize up causing the work
piece, jig, or fixture to rotate with the spindle and can cause serious injury.
Remove Key Chucks: When a key chuck is used, remove it immediately after using it to lock or unlock a tool in
the chuck. If it is not removed, starting the spindle can cause it to be thrown off the chuck and could result in
serious injury.
Hand Safety: Keep hands away from the spindle when the machine is under power. Never clear chips when the
spindle is under power and never use the hands to clear chips; use a brush or chip rake. Chips are razor sharp
and can cause serious injury. Do Not Change Tools with the Spindle Rotating Under Power.
SAFETY RULES
!