Powermatic 1150HD, Инструкция по эксплуатации

Страница: 10 / 44

10
INSTALLATION, ADJUSTMENTS & MAINTENANCE
RECEIVING
Remove drill press from shipping container and check for damage. Report any damage to the carrier and to your
distributor immediately. Attach accessories shipped with drill press, then clean protective coating from table,
column, base and spindle with a good commercial solvent. Read instruction manual thoroughly for assembly
alignment, maintenance and safety instructions.
INSTALLATION
Mount machine on a solid foundation and lag to the floor through holes provided in base of drill press. The head
and table of the machine have been lowered on the column for convenience in packaging. If your drill press is
not equipped with an optional head raising assembly, you can raise the head by proceeding as follows:
1. Place a block of wood on top of table and under spindle nose. Raise table until spindle nose contacts the
block.
2. Loosen head locking handles, bumping them lightly to make certain they release.
3. Turn handle counter - clockwise (toward the operator). Head will move upward 6".
4. Lock head again with locking handles, raise table to a position just under spindle nose and repeat steps
2 through 4.
5. If the above procedure is too slow, use a minimum of three men to move head to its proper height; two
to lift head and one to perform the loosening and locking of the handles.
6. After head is at proper height, secure tightly, then slide the safety collar up and lock it in place under the
head. This will prevent the head from falling if loosened for swing drilling operations.
WARNING: The drill head will fall if the locking handles are loosened and the safety collar is not
secured beneath it. Always lock the safety collar after head has been positioned.
7. Visually align spindle with table and base.
MULTIPLE SPINDLE MODELS
In the case of multiple spindle models, the legs are not attached to the table, they are packed separately. To
assemble the legs to multiple spindle models, carefully support machine on forklift tines or other temporary
supports and bolt legs securely into position. The tables of multiple spindle models are at times shipped in more
than one piece. In joining table halves, use alignment pins provided before securing bolts. These pins guarantee
alignment of table surfaces. It is imperative that multiple spindle tables be carefully leveled. Use a precision level
and level using the jackscrews provided in the legs. Lag machine to floor through holes provided in legs.
MOTOR INSTALLATION
Step Pulley Models (1150A):
If your machine was ordered less motor, or if the motor is being replaced, the following instructions will
make installation easier.
a. Place motor pulley on motor shaft and insert key.
b. Raise drill press table as shown in Fig. 1. Place motor upright on table and install motor to motor
mount, using (4) 5/16-18 hex nuts. Align motor and spindle pulley and tighten motor pulley set
screws.
c. Loosen lock handle (Fig. 2) and place belt over pulleys and into lowest speed grooves. Push motor
base clamp to rear for light belt tension and turn lock screw clockwise to lock. Too much tension will
cause excessive vibration, shaft breakage, bearing noise and wear.
!