Powerhouse Force 1800, Руководство по установке и эксплуатации, Страница: 18 / 19

Troubleshooting
14
Troubleshooting
Symptom Cause Recommended action
Washer refuses
to start Trigger not de-
pressed The washer only runs when the trigger is
depressed on the spray gun.
Washer not
plugged in Plug in washer.
Defective socket Try another socket or check GFIC in socket.
GFIC has tripped
on washer Follow directions to reset GFIC on back of
washer plug.
Defective exten-
sion cable Try without the extension cable.
Fluctuating pres-
sure (this will
happen for the
first couple
minutes of use
while air is being
pumped from
washer)
Water supply not
sufficient Increase water pressure, check for blockage
of garden hose, and/or change to larger
hose.
Valves dirty,
worn out, or
stuck
If within the 1 Year Warranty period, e-mail
us at nepowerhouse@gmail.com. If not, take
it to a qualified appliance repair shop.
Pump is sucking
air Check that hoses and connections are air-
tight.
Pump seals worn If within the 1 Year Warranty period, e-mail
us at nepowerhouse@gmail.com. If not, take
it to a qualified appliance repair shop.
Washer stops GFIC has tripped Follow directions on the back of the plug to
reset GFIC. Also check reset button on the
outlet.
Incorrect voltage Check that the voltage corresponds to speci-
fication on the name plate.
Thermal sensor
activated Turn washer off and wait 5 minutes for
washer to cool down.
Nozzle partially
blocked Clean the nozzle with the needle included
with manual, and by spraying water back-
wards through the nozzle.
Washer pul-
sating Air in inlet hose/
pump Depress trigger until regular working pres-
sure resumes.
Inadequate sup-
ply of water Increase water pressure, check for blockage
of garden hose, and/or change to bigger
hose.
Nozzle partially
blocked Clean the nozzle with a needle included with
manual, and then by spraying water back-
wards through the nozzle.